Is Subject achievable & what are prerequisites?thanks in advance
Forum Posts
Hello Team,I am migrating from MDS 9148S to MDS 9148T, I have included a part of Zoneset output below and I can see a unique fcid though, but same WWPN is listed under each zone, please can you explain the logic here.This output is from MDS9148S, I a...
I can see Active Zoneset with the command show zone status vsan or show zoneset active, the hosts are connected and there is FLOGI, but when I run the command “show zone alaysis vsan” I do not see any Zonesets listed, can I ignore, should I create a ...
Hi, I am looking to install N55-8P-SSK9= license on my N5K-C5548UP switch to enable 8 ports for storage. Can I add one more license to my same switch to enable 8 more ports for storage that is 16 ports in total?
MDS9396S was migrated to MDS9396T successfully, the zonesets are detected under Show zone status, but not under Show zone analaysys. copy zone or zone import commands are no more available, please advise.
When I set a unique Domian ID on the new switch, create an ISL between the old and the new, why isn't the complete configuration such as zonesets, zone and fcalias copy over from old to new san switch? why do I have to manually create Fcalias/zones ...
Resolved! Enhanced Zone merge in MDS9396T
I am migrating from 9396S to 9396T through ISL based migration, 9396S (OLD SWITCH) has Enhanced zone set with valid zones,Question is, I shall set Enhanced zone on 9396T, but the warning below is confusing, if I continue, doesn't the empty zoneset ge...
Hi experts I want to confirm if i can establish a port-channel between 2 MDS 9396V using 4 ports each side. A consideration to have in mind is that 2 interfaces have fibers with 7km lenght and the other 2 interfaces have fibers with 10km lenght. (Sam...
Hello, I need to replace the MDS 9148 with the new MDS 9148T. What is the best procedure to do it? 1. Can I take a configuration file from the old 9148 to the new 9148T? 2. Can I use the zone migration tool?
I have customer desparated to replace the 48P N5Ks which connects both compute as well as native FC SAN...But from what I can see, there are not many N9K models support native FC anymore...I guess I could recommend MDS but they would still need data ...
Hi.We have 9336C-FX2 and i trying to configure it for SMB-Direct RDMA using PFC. If i globally enable PFC watch-dog forced, Queue goes to state Shutdown even if watchdog is off traffic won't goes. Howewer on old 9396PX with N9K-M12PQ module everys fi...
Hi We removed the zoneset for a particular vSAN id and then created a new zoneset for that VSAN (saved the changes by copy run start). When we run show zoneset, it's shwoing only the newly created zoneset, but with show run it's showing up both the z...
Hiwe have 4 data centres and I have been tasked with configuring zoning on our Nexus 9k's and 5k,s I have done this before and had no issues but now we have new vsans created and these are for the new storage volumes is it possible to have x2 active ...
Hi all,I have a design question related to FCoE and FC scalability. The idea is to provide additional FC and FCoE capable ports in the network on new 9318yx-fx switches.As per documentation, we can run additional switches in NPV mode and they can pr...
Hi Community, Does the Nexus 93180YC-FX NX-OS switch already support Fiber Channel interfaces? - The datasheet says, that the downlink ports are FC capable - The NX-OS configuration guide does not mention Fiber Channel interface configuration, only...
