10-29-2012 07:03 AM
I have two fabric's with in each fabric four 9124's and one 9148 (5.0(1a)
In one fabric the setup from ISL's to port-channels worked with no problem, in the other fabric there is no way i can set up prot-channels
After creating the port-channel bij cli the error on one interface is (Peer device doesn't support port-channels).
Creating the port-channels wikt FM also gives a error about the non supporting peer.
Checked all settings with the switches in the fabric that's working fine, and can't see any differences.
Error is below:
SWxx(config)# sh int ext2
ext2 is down (Peer device doesn't support port-channels)
Hardware is Fibre Channel, SFP is short wave laser w/o OFC (S
N)
Port WWN is 20:0e:00:0d:ec:c5:00:80
Admin port mode is E, trunk mode is off
snmp link state traps are enabled
Port vsan is 2
Receive data field Size is 2112
Beacon is turned off
Belongs to port-channel 50
6662 frames input, 693748 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
0 too long, 0 too short
6633 frames output, 542572 bytes
0 discards, 0 errors
16 input OLS, 12 LRR, 14 NOS, 22 loop inits
22 output OLS, 16 LRR, 13 NOS, 5 loop inits
Interface last changed at Mon Oct 29 13:34:16 2012
SWyy(config)# sh int fc1/11
fc1/11 is down (Link failure: OLS received)
Hardware is Fibre Channel, SFP is short wave laser w/o OFC (S
N)
Port WWN is 20:0b:54:7f:ee:99:05:70
Admin port mode is E, trunk mode is off
snmp link state traps are enabled
Port vsan is 2
Receive data field Size is 2112
Beacon is turned off
Belongs to port-channel 50
What am i doing wrong ??
Solved! Go to Solution.
10-29-2012 07:59 AM
Hi Martin,
Make sure trunk protocol is ebabled on the 9148 and on the edge:
show trunk protocol examples:
switch1# show trunk protocol Trunk Protocol is enabled wwitch1# switch2# show trunk protocol Trunk Protocol is disabled <<< disabled switch2#
To enable trunk protocol:
conf t
trunk protocol enable
exit
copy r s
Best regards,
Jim
10-29-2012 07:59 AM
Hi Martin,
Make sure trunk protocol is ebabled on the 9148 and on the edge:
show trunk protocol examples:
switch1# show trunk protocol Trunk Protocol is enabled wwitch1# switch2# show trunk protocol Trunk Protocol is disabled <<< disabled switch2#
To enable trunk protocol:
conf t
trunk protocol enable
exit
copy r s
Best regards,
Jim
10-29-2012 08:13 AM
Hi Jim,
Seems that Google is not my only friend,
Thanks a lot, enabling trunk protocol solved the problem it was indeed disabled.
Best regards,
Martin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: