cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

CFS and Zone Distribution NX-OS 6.2(1) MDS9500

ndavis2001
Beginner
Beginner

Hello all!

Ihave a question. My SAN layout is configured of 4 switches (2 remote/2 local).

Fabric A:

Switch1   <-------  DWDM  -------- > Switch 3

Fabric B:

Switch 2 <-------  DWDM ---------> Switch 4

I made a change to the Call Home feature on switch 1, however it sent the contact infor and everything to switch 3. I am not the contact person for switches 3 & 4.

My question is this:  If I turn off CFS, will it interfere with the zoneset distribution?  I need the switches to be aware of the zones in both fabrics.

Any help is appreciated.

Regards,

Nathan

1 ACCEPTED SOLUTION
2 REPLIES 2

dakester,

Thank you for your response. That ahs definitely helped me. I disabled CFS using your suggestion.  However, when I did I saw that the callhome was still under CFS control (device manager said that CFS was still enabled).  Thus I found the distribute command under the callhome section. I executed the following commands:

conf t

calhome

no distruibute

ctrl-z

That helped me completely remove the callhome feature from CFS control. 

Thank you for putting me onto that path!

Regards,

Nathan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: