GVRP CISCO SG 300

[juanargen2007]

Dear team,
we need to install 2 switches model sg300 24p with gvrp.
I have followed the instructions to set this protocol but it doesn't work.

I´ve tried with 2 differents firmwares.

I just need create 15 vlans and  replicate in others 2 switches with the same model.

Best regards.

Juan Moreno

[lparikh]

Hello Juan,

Thank you for visiting the Cisco Support Community!

Below are some articles I have found in our Knowledge Base that may be able to help you with this configuration. 

Configuration of GARP VLAN Registration Protocol (GVRP) on 300 Series Managed Switches

GARP VLAN Registration Protocol (GVRP) Settings on SFE/SGE Managed Switches

If this post was helpful, please remember to mark this question as resolved to help others in the community. If you have any further questions regarding Cisco’s small business products, please do not hesitate to ask!

Best,

LP

[juanargen2007]

Dear LP.

thanks for your reply.

i forgot tell in my thread  that i check thats manuals and still not works.

step by step!

i have read more people have the same issue with this model.

[Brendan Kearney]

yes, i am one of those that have this issue, and the same default "read these manuals" answer did me no good.  i did follow them, both before and after i posted my thread, and no improvement in functionality was seen.

what is the problem with GVRP on the SG series of devices?  why doesnt it work?

[Yiu Kay Lee]

Hello,

Please check out this document

https://supportforums.cisco.com/blog/12586426/gvrp-configuration-guide-sx500300