How to access C2960 switch using Cisco Network Assistant.

[techcoora]

I can not figure what Username and password to use for "Please enter your username and password for Level 15 access on "192.168.1.253" when I enter 192.168.1.253 in Connect to: and select OK.

The lever 15 username and password that I can use for SSH does not work.

[Milos Megis · Accepted solution]

Hello,
try to insert your enable password (enable secret password) with blank username.

This is default authentification of HTTP server.

You can change it with command:
ip http authenticaton ...

[techcoora]

Yes, that does work in spite of me entering aaa new-model

I found ip http authentication local changed so username and password for Level 15 worked for CNA logon

Is there another way CNA can be accessed?

Is there a way to access using the ip http secure-server?

[Milos Megis]

You can enable ip http secure-server and login to web management with https://ip_address_of_switch

But I never used CNA. I prefer CLI :-)

I have also tested that if you deny telnet connections then you will not able to connect to http server

[techcoora]

Let me switch the rest of this discussion to Discussion How to use the WEB BASED DEV MGR?