06-12-2015 02:57 AM
We have SG-500 Switch in our network where Polycom IP phones are connected. We are using basic QOS mode. Below is the configuration for port where phone is connected.
AP-PUNE-ASW05#sh run int gi1/1/2
interface gigabitethernet1/1/2
spanning-tree bpduguard enable
qos cos 5
switchport mode access
switchport access vlan 53
!
AP-PUNE-ASW05#
Now let me know how to check if traffic from phone on above port is getting assigned with cos 5.
06-12-2015 09:34 AM
Hi Sandesh,
You can try to check with qos statistics queues if you can see queue 4 statistics is good. If you still not sure than you may need to run wireshark on Linux and mirror traffic from uplink ports and search for dot1q tag. On Windows unfortunately is not easy to see.
Regards,
Aleksandra
06-18-2015 02:01 AM
This is queue 4 stats i see on port GE1/1/2 & 18 where phones are connected.
I am not able to mirror trunk port on this switch. It shows status not ready.
Gi1/1/49 is trunk port & below is its configuration.
AP-PUNE-ASW05#sh run int g1/1/49
interface gigabitethernet1/1/49
description TRUNK2CORE
channel-group 5 mode on
!
AP-PUNE-ASW05#
AP-PUNE-ASW05#sh run int Port-Channel 5
interface Port-channel5
description TRUNK2CORE
switchport trunk allowed vlan add 2,52-54,501-502,552
switchport trunk native vlan 551
!
AP-PUNE-ASW05#
AP-PUNE-ASW05#sh run int g1/1/13
interface gigabitethernet1/1/13
port monitor GigabitEthernet 1/1/49
no qos trust
!
AP-PUNE-ASW05#
Please suggest.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide