Is there any way to filter the output of the command using PIPE in Cisco SB Switches ?

[Giorgi Dvali]

Hello,

I have Cisco Small Business SF300 switch. CLI is more or less similar to IOS, but I can't seem to figure out how to PIPE the output of the command like in IOS: "show log | i fa48".
I was wondering if the software on SF300 switches completely lack the ability to do the PIPE or it is done in some strange weird way ? 

SW version 1.3.0.62 ( date 02-May-2013 time 14:55:01 )
Boot version 1.1.0.6 ( date 11-May-2011 time 18:31:00 )
HW version V03

Thank you in advance,

George

[Brandon Svec]

Even though it looks more or less like ios, it is different.  You can do interface ranges at least, but no search/grep as far as I can tell.  You can search for a detailed CLI guide like this for some more detail: http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/CLI_Nikola300_1_3_7.pdf