SF-300-48P Power Failure

[putter.jc]

Hi,

We have several  SF-300-48P switches, eveytime there is a power failure the switches need to reboot 2 or 3 times before they are able to route packets again. Has anyone seen this before? or have suggestions?

[Tom Watts]

Hi JC, no I haven't heard of this. However, if it is not switching/routing packets after a complete reboot, are you sure the power source has been stabilized?

The switch will not behave correctly if it is not receiving sufficient power.

If I plug/unplug or kill my surge protector many times over I haven't noticed any abnormal issues aside from just a reboot and a few minutes later back to usual.

-Tom
Please mark answered for helpful posts