11-22-2023 09:15 AM
Hi,
I have an SG200-50 switch that I am trying to configure. I have updated to the latest firmware/bootcode: 1.4.11.5 / 1.3.5.06.
I am unable to change the vlan management interface to my own VLAN. it will only allow vlan 1. I have a few of these switches and those do not exhibit this issue. I have tried changing to a static IP address first and rebooting as has been suggested. This did not help.
I'm at a dead end here with tis unit as its not ideal to only be able to use VLAN 1 for management. Thanks in advance.
11-22-2023 09:27 AM
M.
11-22-2023 09:44 AM
11-22-2023 10:04 AM
- Are these the exact same model and or running same firmware version ?
The one I tested on : https://community.cisco.com/t5/online-device-emulators-small-business/bd-p/911-discussions-online-device-emulators
has the same behavior as your not-allowed example ,
M.
11-22-2023 10:23 AM
they were on close firmware. the one I'm having the issue with was 1.3.x. and the other one is 1.2.x I updated to the latest trying to resolve this issue, as I found another port suggesting to update firmware.
So using step 2 I was able to change the management VLAN, however I am unable to connect to the switch from a tagged port. I can only connect from an untagged port. My properly functioning switch I am connecting over a tagged port. Any idea why I can't connect on a tagged port?
11-22-2023 11:58 PM
>... Any idea why I can't connect on a tagged port?
- Check the logs on the SG when trying ,
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide