SG200-8 Static mac address problem

[Boris Bahes]

Hi!

My second problem with sg200-08 (firmware: SG200-08x_FW_1.0.6.2.stk) is when I try to add specific MAC address as secure:

MAC Address Tables - Static Addresses - Add; insert vlan id, port, mac address and select "Secure":

I get error message: "Error: Failed to Add 'Static Address' entry.

Again, thanks for reply!

Best regards,

Boris Bahes.

[Tom Watts]

Hi Boris, do you have port security enabled for the port? Secure is used in conjunction with port security.

-Tom
Please mark answered for helpful posts

[Boris Bahes]

Yes, port security is enabled.

PS. I have downgraded firmware to 1.0.5.1 and problem is still there.

[Boris Bahes]

Problem solved with second upgrade to new firmware SG200-08x_FW_1.0.6.2.stk this time using TFTP.

[MLipfert1]

I have the same problem using the current firmware 1.0.6.2. But even an upgrade by TFTP followed by a factory reset does not help. A downgrade to firmware 1.0.5.1 also does not fix this issue.

Are there any other suggestions?

[viningele]

Could try the newest firmware and boot release 1.3.5.58.

[MLipfert1]

1.3.5.58 for SG200-08? There is only the firmware 1.0.6.2 on the official download page.

[Boris Bahes]

Moritz Lipfert wrote:
I have the same problem using the current firmware 1.0.6.2. But even an upgrade by TFTP followed by a factory reset does not help. A downgrade to firmware 1.0.5.1 also does not fix this issue.
Are there any other suggestions?

Strange as it may sound, try playing with compatibility mode in Internet Explorer. I have found that these switches interface respond well only in IE.

[viningele]

Release Notes for 200, 300, 500, and ESW2 Series Switches Software Version 1.3.5.x.

[MLipfert1]

The release notes show that the firmware 1.3.5.58 is not compatible with the model SG200-08.

If I try to configure the static MAC adresses with Internet Explorer 9 onwards with or without the compatibility mode it throws a Javascript error in a firmware script file (xui_model_window.js).