09-27-2018 03:04 AM
Hello,
we just received a SG220-26P Poe Switch. We are tring to power on a passive poe device ( Ubiquiti Rocket Prism GEn2 - https://www.ubnt.com/downloads/datasheets/RocketAC/Rocket_Prism_AC_Gen2_DS.pdf). I think this is no autosensing, no 802.x standard. How can I enable PoE manually. This device need 9500 mw max power. Is it possible?
Regards,
Gianmaria
10-02-2018 12:25 AM
Hi,
Passive PoE does no such negotiation, and as such is always sending electric current out over the ethernet cable at a certain voltage regardless of the device it’s going to.
You can try with legacy POE mode or manual set required power
See the guide (page 360) :
Regards,
Deepak Kumar
10-02-2018 04:04 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide