SG300-10 IPv4 Routes Bug

[schoep851]

Hello together

I bought the SG300-10 Switch a few days ago and updated it to firmware 1.3.0.59, but i think there's a bug in this firmware.

If I go to "IP Configuration" IPv4 Routes" in L3 Mode nothing is displayed. In the log file i see that:

2147477311	2013-Mar-16 09:51:34	Error	%HTTP_HTTPS-E-DIAGNOSTICS: ERROR - in <RL_vtLeadTableGet> tag, can not find the table rlInetRoutingDistanceTable in the MIB.
2147477518	2013-Mar-14 22:39:22	Error	%HTTP_HTTPS-E-DIAGNOSTICS: ERROR - in <RL_vtLeadTableGet> tag, can not find the table rlInetRoutingDistanceTable in the MIB., aggregated (1)

Reset of the Switch doesn't help.

Anyone have the same problem?

Thanks for help.

[Tom Watts]

Hi Ephraim, there shouldn't be routes unless you make a SVI and have an active connection or you make static routes.

-Tom
Please mark answered for helpful posts

[schoep851]

Hello Tom

I have 4 VLAN's and can also add a static route, but nothing appears in the Web-GUI.

With the CLI command "show ip route" i see the routes.

Thanks.

[Tom Watts]

Seems you're right. Interesting. I'll chip away at this and see what I can find.

-Tom
Please mark answered for helpful posts

[Tom Watts · Accepted solution]

Hi Ephraim, this is a known bug and should be resolved in the upcoming maintenance release 1.3.0.62. I cannot give an ETA for the release of this software. However, if this is a pressing issue, please contact the small business support center requesting an escalation to the tier 2 team and asking for the firmware.

-Tom
Please mark answered for helpful posts