SG300 update boot code from old version
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-11-2023 12:15 PM
Hi everyone,
I have a problem with a Sg300-10 10-Port-Switch. The switsch runs on boot version 1.0.0.4 and firmware version 1.3.0.59. I would like to update the boot code so I can update the firmware to the latest version. I can only find the boot update 1.3.0.56 on the cisco site but the switch said that this version is to old. What can I do? are there updates between this versions that I can install first?
thanks in advance
- Labels:
-
Small Business Switches
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-12-2023 04:12 AM
- Check if you can upgrade to the latest firmware in which distribution this particular boot code is distributed too , then check if you can go to the latest firmware release (too) ,
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-12-2023 08:51 AM
as per i know some time back Cisco dropped the 1.3 firmware version and moved to 1.4.X
you can directly upgrade firmware to 1.4.X (latest s 1.4.5) always read the release notes.
the boot version automatically upgrades part of the firmware upgrade
read release notes:
