SG300 update boot code from old version

[lukiboy]

Hi everyone,

I have a problem with a Sg300-10 10-Port-Switch. The switsch runs on boot version 1.0.0.4 and firmware version 1.3.0.59. I would like to update the boot code so I can update the firmware to the latest version. I can only find the boot update 1.3.0.56 on the cisco site but the switch said that this version is to old. What can I do? are there updates between this versions that I can install first?

thanks in advance

[marce1000]

 -  Check if you can upgrade to the latest firmware in which distribution this particular boot code is distributed too , then check if you can go to  the latest firmware release (too) , 

 M.

[balaji.bandi]

as per i know some time back Cisco dropped the 1.3 firmware version and moved to 1.4.X 

you can directly upgrade firmware to 1.4.X (latest s 1.4.5) always read the release notes.

the boot version automatically upgrades part of the firmware upgrade

read release notes:

https://www.cisco.com/c/en/us/support/switches/small-business-300-series-managed-switches/products-release-notes-list.html