04-27-2022 04:35 AM
I am trying to configure some SNMP settings on my SF350-48MP switch but I get the error '% Wrong number of parameters or invalid range, size or characters entered'. The command is shown below:
snmp-server enable traps mac-notification change
snmp-server enable traps snmp linkdown linkup coldstart warmstart
Note: These commands work seamlessly on my catalyst switches.
04-27-2022 04:51 AM
Hi
Probably the command is different from catalyst. I´d recomend to enable it using web interface instead.
Applicable Devices
Sx250 Series
Sx300 Series
Sx350 Series
SG350X Series
Sx500 Series
Sx550X Series
04-27-2022 05:44 AM
Thank you for your response. I have tried using the web interface but it's not giving me what I want. I have setup snmp on the switch, but I need it to send mac notification changes to the host. Clearly, the command is different, I just need help figuring out the exact command to run on the switch.
04-27-2022 06:22 AM
Basically, everything configurable via CLI must be done via Web Interface. It sounds to me that you switch does not do what you intend to do.
You can check on the switch command manual.
04-27-2022 07:01 AM
I will continue to keep at it, hopefully, there's a solution to this issue. Thank you for your contribution.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide