09-28-2013 07:06 PM
Has anyone here tried to mix a Catalyst switch (say, a 3500 or 2950) with a Cisco SG200-26?
I've got 4 VLANs setup on a 3500: 1 (default), 10, 20, and 30 I've tried to connect a trunk port (GBIC) out of a 3500, into a SG200, with the hopes of being able to assign ports to those particular VLANs on the SG200. So far, I've only been able to work on the default VLAN 1 on the SG200.
The only options I can see, are that I can create VLAN's on the SG200, and assign ports that way --- but that doesn't seem to be passing the VLANs, just creating them fresh again -- I think
Anyone have any thoughts or experience with this?
Recap:
Out of the 3500:
interface GigabitEthernet0/1
description Trunk_To_SG200
switchport trunk encapsulation dot1q
switchport mode trunk
Connected to the SPF port 26 on the SG200-26
Plugging into ports 1-24, I get a DHCP address from the default VLAN 1
09-29-2013 06:08 AM
Hi Andy, you could make a LLDP policy on the Catalyst to force the Sx200 smart ports to respond.
https://supportforums.cisco.com/thread/2180209
-Tom
Please mark answered for helpful posts
10-01-2013 10:43 AM
Andy,
Please upload a sanitized version of your configuration and I will take a look at it.
Richard
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide