VoIP QoS on SGE2010p

[750langlois]

hello,

Need help to configure QoS on a SGE2010P.  It's for VoIP. I setup it's own vlan but doesn't seems to be the solution.

What is the best way to set it up? i already look at that document but i'm not sure what to do http://www.cisco.com/en/US/docs/switches/lan/csbms/sge2000/reference/guide/sge_refguide.pdf

Any advice is appreciate.

[paolo bevilacqua]

Wrong forum, post in "small business - switches". You can move your post using the actions panel on the right.

[Davidwagman1]

Hi,

Take a look at this thread. The SGE2010p is slightly different, but the web ui should be relatively similar:

https://supportforums.cisco.com/message/3683639#3683639

Best,

David

Please rate helpful posts.

[750langlois]

Hello David,

Nice post, but the SGE2010p seems to be a little different..   have a look at this and let me know what you think about it..

1st i set up the advanced mode here..

i create the policy table here;

ClassMap is a little bit different.. 

I can't select any because no ACL has been created..  but i do not know where to create ACL.

Any Idea?

[Davidwagman1]

After you add a Class Map, go into policy table. Are you able to add/edit the policy to include that class map?

Best,

David