cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
625
Views
0
Helpful
3
Replies

1712 High Processor Utilization

m-sherman
Level 1
Level 1

Hello,

I am running a 1712 12.4(25d) with NAT, VPN and FW/IDS.  I have a broadband ethernet connection at 20mb.  As I run some traffic through it, the processor jumps up to near 100% and throughput comes to a screeching halt.  IP CEF is turned on and makes no difference when it is turned off or on.

Anyone have any ideas?

3 Replies 3

nkarpysh
Cisco Employee
Cisco Employee

Hello,

What does show proc cpu sort show? Any interfaces which have increase in traffic (show int)?

Nik

HTH,
Niko

Nik,

There are 3 processes that are running individually running less than 1% each.  My "WAN" interface pointing toward the ISP runs about 3MB/200 packets/sec.  I've disabled IDS on that interface with no decrease in CPU utilization...

Can you please provide output of  "show proc cpu sort".

Nik

HTH,
Niko
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card