12-06-2016 02:38 AM - edited 03-08-2019 08:27 AM
Can you assign an IP address to an SVI on the 2960-X.
If not, can it be configured with a management address?
Thanks
12-06-2016 03:04 AM
Yes you can assign IP to SVI on 2960x
You can also configure management port
12-06-2016 09:09 AM
Thank you for the reply.
Out of interest where can you find information on the other features available on the 2960X?
I tried the Cisco Navigator but it doesn't seem to work.
The IOS we are looking at is the LAN Base 15.2.2E5 MD
12-06-2016 02:16 PM
What spesific feature are you looking for?
Here is a link to the data sheet and supported features:
http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-x-series-switches/data_sheet_c78-728232.html
HTH
12-06-2016 02:32 PM
We need to know what features/commands are available with LAN Base 15.2.2E5 MD.
The Cisco Navigator site does not provide any information for this IOS when used with the 2960X
12-07-2016 08:33 AM
I hope this will help you
http://www.cisco.com/c/en/us/support/switches/catalyst-2960-x-series-switches/products-installation-and-configuration-guides-list.html
12-08-2016 04:44 AM
Thank you Bilal.
I think until the Cisco Navigator is working properly this is the best information available.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: