cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3532
Views
0
Helpful
2
Replies

2960S-48TS-L take 10 minutes to boot and start, why?

Echo Chan
Level 1
Level 1

Dear Expert,

May I know why my 2960S-48TS-L takes 10 minutes to boot and start, some just take 1 minute, but one of them take up to 10 minutes, but after that it works fine, why?

Thanks

2 Replies 2

Arumugam Muthaiah
Cisco Employee
Cisco Employee

Hi Echo,

Do you the console los while the switch bootup time? I am not quite sure why does it taking long time to boot but you could try this below option, then check the performance.

  • Reformat the flash
  • Download the IOS image again (make sure you have enough room avilable to copy image on flash drive)
  • Please ensure that you don't reboot until you verify that there is a good IOS image in flash.
  • Then reload the switch, and check the performance

Regards,

Aru

*** Please rate if the post is useful ***

Regards, Aru *** Please rate if the post useful ***

thanks, let me check, I will come back to you when have the result.

Review Cisco Networking for a $25 gift card