2960S Flexstack cabling depth

[robspain2004]

Hi

I wan to install a 2960S stack in an ADC patch frame that has a wall directly behind it.

I will have about 100mm (4 inches) clearance between the rear of the 2960S and the wall.

Is that sufficient clearance to install/remove the flexstack cables without damaging the cables? (i.e. too tight a turn radius) 

Thanks

Rob Spain

UK

[Reza Sharifi]

Rob,

It is going to be very tight, because the tip of the flex cable is about 1.5 to 2 inches long. You also need room for you hand to install/remove the cables without damaging them.  Also, with that much clearance, you can not remove the FlexStack module without undoing the switch from the rack.

HTH

Reza

[robspain2004]

Thanks Reza. Appreciated