06-22-2021 12:25 PM - edited 06-22-2021 12:26 PM
Looking at two different stacks of switches, both running the same ios. (150-1.SE2) both have lldp enabled (lldp run)
On one switch, I'm showing the following:
Gi1/0/6 auto on 24.5 Ieee PD 4 30.0
Gi1/0/10 auto on 4.4 MINET_6920 1 30.0
In this switch, I don't have any power related configs on the interface.
On the other one
Gi1/0/1 auto on 15.4 Ieee PD 4 30.0
Gi1/0/2 auto on 30.0 Ieee PD 4 30.0
Gi1/0/16 auto on 15.4 MINET_6920 1 30.0
In this switch, if I don't have any power related configs on the interface, ports show consuming 30w. The ones showing 15.4 watts is because I restricted with "power inline consumption 15400"
Any ideas?
06-22-2021 04:04 PM
what is the end device?
06-22-2021 09:41 PM
Depends on the POE standards and how the end device is negotiating power usage
Check the power negotiated over LLDP
## Make sure to mark post as helpful, If it resolved your issue. ##
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide