2960s Stack Port shutdown

[MATTHIAS SCHAERER]

Hi,

I have a single 2960s without stack module. The stack port has a status of down, however I'd like to disable it so that it does not generate a false alarm in my NMS. The documentation states that there should be a command "switch 1 stack port 1 disable" but the switch (running 15.0(2)SE2) doesn't seem to  be available. Is this a dcumentation bug or is the command not there at all?

Any hints are appreciated.

Mat

[Leo Laohoo · Accepted solution]

The command exist.  You need to invoke this in ENABLE mode and not in configuration mode.

Besides, you reboot this switch and you need to enter the command again.

[MATTHIAS SCHAERER]

Thanks Leo,

I have not seen your answer up to now. Weird idea to move that to enable mode. Must have been a party day in the programming section....

Regards,

Mat