- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2019 08:54 AM - edited 03-08-2019 05:02 PM
Hi everybody!
Got a question from a partner that is about to improve and secure switching on three different sites.
He has 6 2960X in place, 2 at each site, and now he wants to
1. Stack them with with flex stack
2. Use RPS2300 to secure uptime.
Is this combination possible on a 2960X?
Two 2960X stacked together with flex stack
Power supplied with RPS2300, one per switch.
BR
Andreas
Solved! Go to Solution.
- Labels:
-
LAN Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2019 10:45 AM
Hi,
The stacking should work fine. Also, the RPS is a separate unit that connects to the switch and should not have any effect on stacking.
HTH
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2019 10:45 AM
Hi,
The stacking should work fine. Also, the RPS is a separate unit that connects to the switch and should not have any effect on stacking.
HTH
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2019 01:13 PM
Hi, thanks.
I found this print a minute ago. Which confirms your respons.
Have a nice evening.
BR
Andreas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2019 01:41 PM
Good Luck Andreas!
