cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4585
Views
0
Helpful
4
Replies

2960x reload command issue

Vui Han Lim
Level 1
Level 1

Hi Cisco,

I believe this not I'm the only one facing such issue when execute reload command

I tested 2960x as version below 

normal execute reload for member or other switch by type  reload slot 2, it working fine by type reload slo 2

when I typo reload slor 2, switch dont prompt me error , but seeking confirm; In this kind situation , i just press enter because i assume i type it correctly

Surprise, it reload entire stack switch

so i test with recommend version

same issue happen, it reload entire switch stack

if we typo reload slotx 2, it still reload entire stack

please look into this issue

1 Accepted Solution

Accepted Solutions

julijime
Cisco Employee
Cisco Employee

Hi Vui,

The behavior that you're observing is expected as you're not using the correct syntax in order to reload the slot needed.

The correct command is the following, please notice the correct keyword "slot":

SWA#reload slot 2

 

By typing "reload slor 2" you're telling the stack to reload all the members due to the reason "slor 2" which is used management and logging purposes.

Please see the following link for additional details on this command:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/stack_manager/command_reference/b_stck_152ex_2960-x_cr/b_stck_152ex_2960-x_cr_chapter_01.html#wp3486313748

View solution in original post

4 Replies 4

julijime
Cisco Employee
Cisco Employee

Hi Vui,

The behavior that you're observing is expected as you're not using the correct syntax in order to reload the slot needed.

The correct command is the following, please notice the correct keyword "slot":

SWA#reload slot 2

 

By typing "reload slor 2" you're telling the stack to reload all the members due to the reason "slor 2" which is used management and logging purposes.

Please see the following link for additional details on this command:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/stack_manager/command_reference/b_stck_152ex_2960-x_cr/b_stck_152ex_2960-x_cr_chapter_01.html#wp3486313748

Noted, but is too dangers for me or any engineers out there reload entire stack when issue wrong command

Mark Malone
VIP Alumni
VIP Alumni

Hey that's an experimental IOS your on (EX) it will have a lot of bugs in it , you should change the IOS to an MD release and test again

The recommended image for that switch is 15.2.2E3

Review Cisco Networking for a $25 gift card