02-10-2013 03:52 AM - edited 03-07-2019 11:37 AM
Is it possible to arrange the stack switches as per physical location on the rack, and without changing interfaces configuration?
Thanks,
Ali
02-10-2013 07:50 AM
Hi,
the only way i know is the "renumber" command.
But afaik this kills the interface configuration ...
If the cables are long enough, the screwdriver is the easiest way, hehe.
02-10-2013 12:31 PM
If you renumber your switches, in order for it to take effect, you have to reboot the stack. Once the switches are rebooted the config will change.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide