- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2018 08:59 AM - edited 03-08-2019 03:25 PM
Hello,
here is my scenario....I have 5 3750 switches stacked (1-5) and i want to remove switch 2 (slave). What would be the best way doing this WITHOUT any reboots? Can I just remove switch 2 and then switch 3 will becomes slave? Is there any election process stack will do for slave? I don't want my stack to reboot. Thanks
Solved! Go to Solution.
- Labels:
-
Other Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2018 09:49 AM
It should not reboot other switches.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2018 09:45 AM
Kindly rate for helpful post
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2018 09:46 AM
Thanks for your reply...
any reboots happen during this change? I will change the stack cables configuration after I shutdown the switch.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2018 09:49 AM
It should not reboot other switches.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2018 09:50 AM
