10-22-2021 10:15 AM
hi,
I need to upgrade 3850 stack of two switchec in bundle mode. Can I upgrade one at the time, just to be sure that one member will work ok?
br
10-22-2021 10:50 AM
If this is a stack you need to Upgrade the stack as the best approach.
If you like to each one, split the stack and upgrade and join back. ( this required more downtime)
Make sure you read the release notes from what version your version vs the target version and understand any bugs.
Note: always offload current working config out of the box.
10-22-2021 01:32 PM
you can just upgrade master switch, aka switch #1 then others will upgrade software from it; We did it when replacing old with new and had to do upgrade. I think it takes about 20 minutes and command is "software auto install" but check Cisco doc page for 3850s. we install and upgraded master switch; then turn on 2nd switch and issue software auto install command. Not sure if it is possible to accidentally downgrade master from 2nd one.
Regards, ML
**Please Rate All Helpful Responses **
10-22-2021 05:45 PM - edited 10-22-2021 05:46 PM
@DraganSkundric87318 wrote:
I need to upgrade 3850 stack of two switches in bundle mode.
What is the current version of the stack?
What is the intended version to be upgraded to?
@Martin L wrote:
command is "software auto install"
This command is not going to support Bundle Mode.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide