10-20-2026 04:46 AM
i have a 3850 stack of 2 switches in my mdf. i have another switch in my idf connected by fiber. everything has been good for years. i just added another 3850 switch into my stack in my mdf. now i cant access by idf switch at all. cant ping or putty it. but it shows in show cdp neighbor. i have some FortiAP's on switch 1 in my mdf stack. i keep losing them every so often. i'll run a constant ping to something else behind the network and i lose 6 packets every time when this happens. i drop all packets into this network whenever this 6 packet drop happens. i even took that switch i added out of the stack and it doesnt matter, the same problem. It was a bare switch. same OS. ive done this many times in my network but never had this happen before.
Solved! Go to Solution.
11-02-2026 08:49 AM
found issue. it was something over looked. it had a mgmt vlan setup but when adding the switch it sorta removed it. settings were there but not working. just added back the vlan resolved all issues.
10-20-2026 05:04 AM
- @awojtowicz Check logs on the stack when manipulations are done, such as adding or deleting
a stack member , do the same on other switches involved in the issue; if any
Use and or define a common syslog server which is a better solution for collecting logs
M.
10-20-2026 10:24 AM
Since the issue started after adding the new 3850, I’d check the stack and uplink status first, even though removing the switch didn’t fix it.
You can check show switch, show switch stack-ports, and show interfaces counters errors to see if there are any stack-port or interface errors. I’d also check the fiber uplink to the IDF switch and compare the running configs to see if anything changed with VLANs, trunks, or spanning tree.
The fact that the IDF switch still shows up in CDP but you can’t ping or SSH into it is a useful clue.
10-20-2026 01:49 PM
Post the complete output to the following commands:
sh platform resources
sh platform software status control-processor brief
10-21-2026 06:36 AM
10-21-2026 02:50 PM
Can you check the output to the command "sh controller util". This command is a real-time snapshot of each link utilization (upload and download).
Anything more than 10% is not good.
10-22-2026 04:08 AM
10-22-2026 03:22 PM
Memory utilization is normal.
Real-time link utilization is normal.
I do not see any evidence coming from this switch that this is the source of the packet drops.
Try this: Plug a machine in the same switch member, put in the same VLAN as the machine dropping packets.
Ping the machine dropping packets. Are the packets dropping?
11-02-2026 08:49 AM
found issue. it was something over looked. it had a mgmt vlan setup but when adding the switch it sorta removed it. settings were there but not working. just added back the vlan resolved all issues.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide