02-14-2011 11:49 AM - edited 03-06-2019 03:32 PM
Has anyone run into this issue before? Two 5548 switches running switch profile and it got out of sync (probably because one of the switches lost power before it has chance to save configure). Once the switch profile out of sync, you can't make any change to the switch profile any more, verification will fail.
Is there any good way to get the switch profile resync without recreating it?
Thanks,
Yatao
08-19-2011 05:43 AM
Hi,
Ever found a solution for this problem?
I've run into same problem.
I'manually synced both switch configs but config sync only works from one side.
If i config on one swich it sucseeds and from the other side the commit and the verify fails. Strange isn't it?
03-06-2013 08:19 AM
Yatao,
I ran into a similar issue with our 5Ks as well. What we had to do was the following (environment is dual-homed FEXs running 5.2(1)N1(3) code):
I used the following link to troubleshoot any import issues, etc.:
Good commands to troubleshoot with for import issues: 'show switch-profile status', 'show switch-profile session-history'
Hope this helps, and good luck!
- Joel Metzger
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide