04-01-2017 02:01 PM - edited 03-08-2019 10:01 AM
Hello I am testing my 802.1x wired RADIUS configuation. Howeer, itis not working. My first troubleshooting step is to confirm that the connection between my switch and RADIUS server is OK ?
Does the result of the command below show that I have a good connection between my switch and the RADIUS server i..e secret key and communication good ?
Thank you kindly.
myswitch#sh aaa servers
RADIUS: id 2, priority 1, host 10.5.1.89, auth-port 1812, acct-port 1813
State: current UP, duration 1149s, previous duration 0s
Dead: total time 0s, count 1
Quarantined: No
Authen: request 10, timeouts 4, failover 0, retransmission 3
Response: accept 0, reject 6, challenge 0
Response: unexpected 0, server error 0, incorrect 0, time 9ms
Transaction: success 6, failure 1
Throttled: transaction 0, timeout 0, failure 0
Author: request 0, timeouts 0, failover 0, retransmission 0
Response: accept 0, reject 0, challenge 0
Response: unexpected 0, server error 0, incorrect 0, time 0ms
Transaction: success 0, failure 0
Throttled: transaction 0, timeout 0, failure 0
Account: request 0, timeouts 0, failover 0, retransmission 0
Request: start 0, interim 0, stop 0
Response: start 0, interim 0, stop 0
Response: unexpected 0, server error 0, incorrect 0, time 0ms
Transaction: success 0, failure 0
Throttled: transaction 0, timeout 0, failure 0
Elapsed time since counters last cleared: 1d18h5m
Estimated Outstanding Access Transactions: 0
Estimated Outstanding Accounting Transactions: 0
Estimated Throttled Access Transactions: 0
Estimated Throttled Accounting Transactions: 0
Maximum Throttled Transactions: access 0, accounting 0
Requests per minute past 24 hours:
high - 0 hours, 19 minutes ago: 4
low - 18 hours, 3 minutes ago: 0
average: 0
04-01-2017 03:06 PM
Hi,
From the switch, can you ping the Radius server and from the Radius server, can you ping the switch?
Can you post the config?
HTH
04-02-2017 02:44 AM
HI !
Could you please run this command to test your communication between your system and your raidus server .
HYD-TEST-SW-01#test aaa group radius pc1 P@ssword1 legacy
Attempting authentication test to server-group radius using radius
User was successfully authenticated.
and can you please share your config.. pls
Thanks
CRaju
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide