05-23-2024 04:42 AM
hello
we have 2 x 9300 series switches in a stackwise topology
the ports will not allocate power auto or static to PoE devices of any Class
Q has anyone seen this issue ?
Q could this be license related ? for example the device is not added to the Software portal inventory
the software versions are shown below
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 65 C9300-48P 17.09.05 CAT9K_IOSXE INSTALL
2 65 C9300-48P 17.09.05 CAT9K_IOSXE INSTALL
Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 819.0 0.0 819.0
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Gi1/0/1 auto off 0.0 n/a n/a 30.0
Gi1/0/2 auto off 0.0 n/a n/a 30.0
Gi1/0/3 auto off 0.0 n/a n/a 30.0
05-23-2024 04:43 AM
If the cable is not connected to the switch port.
If the cable is not connected to the powered device.
If the cable has a faulty cable.
If the PD does not adhere to PoE standard.
05-23-2024 07:15 AM
05-23-2024 03:43 PM
What happens if the AP is directly plugged to the switch? Does the AP boot up?
05-23-2024 11:26 PM
You have 2 switch in the stack, but your output show only 1 ?
is this new installation ?
can you post below output :
show version (full)
show post
show cdp
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide