10-16-2019 11:48 AM
Hi there,
Thanks for reading.
I'm having trouble stacking 4 members into a C9300-48U stack. I have redundant PSUs installed and powered. I have all four cables with the Cisco emblem upright (and notched side at bottom). I seated all ends with a nice THUNK and twisted all screws to fully tightened. And still... only switch 1 visible and resonding.
What am i doing wrong?
Thanks!
Bob
Solved! Go to Solution.
10-16-2019 02:39 PM
My process somehow dropped the three member switches into rommon. The switches have matching IOS versions. I individually executed switch:boot on each member. Following the process from that point (new members OFF, cable-connected, powered ON) joined each switch to the stack.
Thank you both!
10-16-2019 12:31 PM
Ensure that you connect the stack cables to the new switches in the stack before you power them on. Also verify that the code version of all switches are compatible with each other.
10-16-2019 02:39 PM
My process somehow dropped the three member switches into rommon. The switches have matching IOS versions. I individually executed switch:boot on each member. Following the process from that point (new members OFF, cable-connected, powered ON) joined each switch to the stack.
Thank you both!
10-16-2019 12:49 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide