05-08-2015 09:37 AM - edited 03-07-2019 11:56 PM
Hi All, trying not to be too vague, but what is the acceptable loss of signal and TX/RX power needed for a 10gig connections?
I'll be setting up a 5mile connection via my companies dark fiber which will pass thru several buildings and LIU's.
I've requested our communications team run a fiber tester on the new link prior to putting any optics on the length.
What would be the range I'm looking for signal and TX/RX power I should be?
The optics I will be using is SFP-10G-ER
Thanks,
Dan
05-08-2015 11:16 AM
Hi,
As long the fiber test shows DB losses are within the secs for single mode fiber, you should be fine.
here is good doc for reference:
http://www.thefoa.org/tech/FAQS/FAQ-TEST.HTM
HTH
05-29-2015 03:45 PM
A post in this discussion has been removed due to possible misconduct. Please refer to the CSC terms of use for more details.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide