02-02-2012 08:26 AM - edited 03-07-2019 04:42 AM
We have recently aquired a remote location which has a pre-existing flat network (172.16.X.X/16). Before we are able to convert them over to our new IP scheme, they have a need to have wireless connectivity on site. We have 4 1142's which I need to configure for them. I have experience configuring WLC's and autonomous AP's for networks with multiple vlans but have never configured AP's for a flat, single subnet network. I need to configure them for either guest access (internet only) or corporate access to network resources with radius authentication. Do I configure a native vlan as I would for a typical multi vlan network? Do I configure the switch port as an access port as opposed to a trunk beacause of the lack of layer 3? I basically need a sample configuration for this situation.
02-02-2012 09:42 AM
https://supportforums.cisco.com/docs/DOC-16087
Does that help?
02-02-2012 10:43 AM
That should do it. Thanks.
02-02-2012 01:18 PM
Dude,
May I ask if you refrain from making multiple post of the same issue? This is your THIRD post.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide