Agian,3750 Speacking

[Ibrahim Jamil]

Hi Folks

Again,3750 Speacking ,why the stack cable hase to be connected forn Stack-1 port on switch 1 to stack 2 port on switch 2 ,while stack 1 port on the switch 1 goes to stack port 2 on switch 1 ,this in case of 2 cable

now in case for 1 single cable from stack port 1 on sw1 to stack port 1 on sw2

[IAN WHITMORE]

This is a Cisco design thing. It's so the switches know if they are at the end of the stack or not or if there are more switches in the stack.

Regards,

Ian