10-04-2012 11:46 AM - edited 03-07-2019 09:17 AM
Hi,
Is it possible to have an asa pair in active/standby mode where the WAN ip addesses are on different subnets?
I had always thought they needed to be on the same lan for it to work.
Thanks
Solved! Go to Solution.
10-04-2012 12:57 PM
Hi Ikadlik,
If you want to use failover as Active / Standby then It can not be possible on diff. Subnet because for that to work, The firewall have to have L2 Adjacency.
Regards
Please rate if it helps.
10-04-2012 12:52 PM
hello,
In ACTIVE/STANDBY mode, both IP Addresses MUST be in the same network address or you can use 2 units for this scenario. One unit primary and second one as backup.
But in juniper it is possible.
please rate if this helps.
thanks
10-04-2012 12:57 PM
Hi Ikadlik,
If you want to use failover as Active / Standby then It can not be possible on diff. Subnet because for that to work, The firewall have to have L2 Adjacency.
Regards
Please rate if it helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide