ASR 1001-X software upgrade

[brianalster]

If this has already been answered, please point me to it and forgive me...

Trying to upgrade a new ASR 1001-X, from universal9.16.05.01b to universal9.16.06.05 from Usb0:

install add  file usb0:asr1001x-universalk9.16.06.05.SPA.bin   but I get the following error.

FAILED: install_add /vol/usb0/asr1001x-universalk9.16.06.05.SPA.bin: /vol/usb0/asr1001x-universalk9.16.06.05.SPA.bin's version Invalid does not match with 16.5.1.0.1432

any guidance is greatly appreciated!!

[Mark Malone]

Hi
copy the file off the USB to the boot flash in the ASR then boot from bootflash , that should work its how i do it on mine

copy usb:..... bootflash:

Then
#sh run | i boot
boot-start-marker
boot system bootflash:asr1001x-universalk9.03.16.07b.S.155-3.S7b-ext.SPA.bin
boot system bootflash:asr1001x-universalk9.03.16.05a.S.155-3.S5a-ext.SPA.bin
boot system bootflash:asr1001x-universalk9.03.16.04b.S.155-3.S4b-ext.SPA.bin
boot system bootflash:asr1001x-universalk9.03.16.03.S.155-3.S3-ext.SPA.bin
boot-end-marker
no ip bootp server

#sho bootv
BOOT variable = bootflash:asr1001x-universalk9.03.16.07b.S.155-3.S7b-ext.SPA.bin,12;bootflash:asr1001x-universalk9.03.16.05a.S.155-3.S5a-ext.SPA.bin,12;bootflash:asr1001x-universalk9.03.16.04b.S.155-3.S4b-ext.SPA.bin,12;bootflash:asr1001x-universalk9.03.16.03.S.155-3.S3-ext.SPA.bin,12;
CONFIG_FILE variable does not exist
BOOTLDR variable does not exist
Configuration register is 0x2102

[brianalster]

boot-start-marker
boot system bootflash:asr1001x-universalk9.16.06.05.SPA.bin
boot-end-marker
no ip bootp server

wr mem

then just reboot/reload the ASR ?

[Mark Malone · Accepted solution]

Yes make sure the image is in flash just in case

dir bootflash:

then check the bootvar as previous post , show bootvar

if it looks good save then reload it should come up with new image