08-07-2008 01:34 AM - edited 03-06-2019 12:39 AM
Hi,
Can you please tell me the command I should be using for the interfaces where my IP phones are to be connected,
I'm unsure if it should be
auto qos voip cisco-phone
or
auto qos voip trust
or both?
Also does the trunk link to the CME router need to have these commands applied?
Thanks,
Chris
08-07-2008 01:59 AM
on the port connected to the ip phone:
auto qos voip cisco-phone
the above comman Enable auto-QoS on the interface, and specify that the interface
is connected to a Cisco IP phone.
The QoS labels of incoming packets are trusted only when the
Cisco IP phone is detected.
on the turnk between swithc to switch or switch to router:
auto qos voip trust
this command Enable auto-QoS on the interface, and specify that the interface
is connected to a trusted router or switch
Please, if helpful Rate
08-07-2008 08:01 AM
Many Thanks,
I have a crossover cable going from the switch into a different vendor switch, for this port would I need to put in "auto qos voip trust"?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide