09-04-2012 10:54 AM - edited 03-07-2019 08:41 AM
Hi All,
I have now to look at QoS, I find switch already configured with Cisco-Pohne auto QoS configured.
currently the following command are configured on the interface configuration :
Interface fa0/1
sw acc vl 1
switchport mode acces
switchport nonego
switchport voice vlan 2
srr-queue bandwith share 10 10 60 20
priority-queue out
mls qos trust device cisco-phone
mls qos trust cos
auto qos voip cisco-phone
spanning-tree portfast
service-policy input AutoQoS-Police-CiscoPhone
but when I issue the command:
show mls qos int fa0/1 queue (on the same switch)
I got the following output information :
Egress Priority Queue : enable
Shape queue weights (absolute) : 25 0 0 0
Shared queue weight : 10 10 60 20
The port badnwith limit : 100 (operationnal bandwith :100.0)
The port is mapped to qset : 1
I red Shape queue override shared queue configuration on the same interface, I understood here the queue 1 has 25% of bandwith reserved and limit to. Queue 2 to 4 has no Shape queue configuration so the 75% on the bandwith remain on that interface would be divised between the remain queue.
I the configuration, I did not find any interface command which configured shapping default configuration for all interfaces on the switch. But I like to understand from where they shapping configuration of the queue 1 is comming from ? their is any default configuration (which is not shown) which can explain this behavior !
I just would like to understand, I'm not very happy to have configured some stuff which I can't explain behavior after fact, when comming time to support them after it would be great to understand those properly.
Thanks everybody !
09-27-2012 01:39 AM
hi Xine,
is your switch configured with auto Qos ?
thanks
09-27-2012 09:30 AM
Hi !
yes it is like specified in the switch port fa0/1 configuration !
"auto qos voip cisco-phone" macro command under the interface fa0/1.
or maybe I misunderstood your question !
09-27-2012 01:40 PM
HI ,
look like it the default Behavior of Auto Qos and it reserve some bandwidth for egress queue.
Just checked in my 2960 and its same.
http://networkenhancers.blogspot.co.nz/2011/05/in-previous-versions-of-qos-2.html
hope this helps.
thanks
09-27-2012 04:55 PM
hi,
check this link its really good and hopefuly will ans your all questions.
https://supportforums.cisco.com/docs/DOC-8093
please rate if this helps.
thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: