Bad stack cable - syslog message?

[Armymanryno]

What command can I run to identify what the error message I was receiving when plugging in my stack cable that does not work? This happened last Friday, so it might not be fresh in the system still.

Thanks

[Mark Malone · Accepted solution]

Hi
You cant really see that youd have to replicate the issue and see it in logs again if there already overwritten or not sent to syslog server , you could check the stack ports though with the below make sure there ok

sh switch stack-ports
Switch # Port 1 Port 2
-------- ------ ------
1 Ok Ok
2 Ok Ok