Switching

Customer has 3 sites and wish to have a 2 GB circuit to the Metro ring at each site,The plan is to run EIGRP routing between all three sites.Not sure if the L3 port-channel will work. Can somebody please advise on this design?### Metro Ring ###VLAN 1...

Attached is the switch configuration, show arp | include Vlan8, and output from my ping/trace for hosts on Vlan 8.On my 6506-E I can ping all the hosts on vlan 8. However, there are some hosts that I can successfully trace to without problems, while ...

At what point would a link become "congested". We have mrtg running and we can see all the statistics, but at what point should we consider adding an additional link(aggregate ports)? Is there a certain percentage when congestion gets high enough to ...

I have an 1811w that is doing my edge.  It has an 8 port switch embedded in it.  It is doing some interior routing (one vlan, several IP subnets) using one of these interfaces.  I want to increase bandwidth to this routing engine from the 100mb it ha...

I know this switch is out of life cycle, but I wanted to still find out what is the following message mean....Port Security: DOT1X: authenticatorstate for port x/x is FORCE_AUTH

Hello,     We have many blade switch C3032 (Dell) in our infrastructure. The fast ethernet interface (management out of band) is configured with a static ip adresse. Today, 80percent of these switch lost the correct configuration to have this configu...

Hi all,I want to config Relay sms in csmars 50-K9 running 6.0.6.Urgent need steps to acheive this and if any respective config on relay device..RegardsAmar

FolksCan any tell me "What is stacking" and what is advantage of stacking in real word. How can i apply the same in my office network.Thnaks,Tamil..         

I have an Ethernet WAN link that terminates on a C3560G and I am looking to give some applications a higher priority or higher bandwith. Does anyone know if the 3560 can do this and what commands would accomplish this?Thanks,

Hello All,I have to configure a port for Printer VLAN on L3 switch. After configuring the port for printer VLAN, the printer IP is not pinging. Same printer is pinging if it is connected to any other switch of the same VTP domain. Troubleshooting don...

I have a couple of 3750 stacks.I am trunking them together (I am runnign BGP on each of them with seperate providers and AS numbers...)I am trying to set up some redundancy int he trunks so should one of the 3750s fail, the trunk will remain up.  I t...