cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
907
Views
0
Helpful
3
Replies

Bonjour service

bluesea2010
Enthusiast
Enthusiast

Hi,

vlan A and vlan b (wired)

the mac device from the  vlan a cannot access vlan b ,

To get it done I should do the following on my distribution 

interface Vlan100

ip address 10.10.10.1
ip pim sparse-mode
!
interface Vlan200
10.10.201
ip pim sparse-mode
!

Since it is using link local address , software switching will happen , this will cause cpu hike  

How to solve this 

Thanks

3 Replies 3

nurbol555
Beginner
Beginner

Hello!

Try to use command  ip pim dense-mode on your VLANs

Hi,

sparse mode is recommended ?

Thanks

Rahul Kachalia
Cisco Employee
Cisco Employee

Hello,

To enable Bonjour service between VLAN A and B, you need to enable Service Discovery Gateway (SDG) feature. And you do not need Multicast for that purpose. Following is the simple configuration example:

service-routing mdns-sd

service-list mdns-sd ANY permit 1

!

interface range Vlan A - B

 service-routing mdns-sd

   service-policy ANY IN

   service-policy ANY OUT

!

This enables Local Area SDG function. If you need Wide Area SDG function across Wired and Wireless or multiple networks/sites then you need to implement with APIC-EM controller solution:

http://www.cisco.com/c/en/us/td/docs/cloud-systems-management/application-policy-infrastructure-controller-enterprise-module/1-3-x/sd-bonjour/release_notes/b_sd_bonjour_rn_133x.html

thanks,

rahul.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: