Please see below output from an 1k Nexus.
When there is only one supervisor module, why does it show sup-1 and sup-2 in show boot command?
N1Kv-1-v5_2# sh boot
Current Boot Variables:
sup-1
kickstart variable = bootflash:/n1000v-dk9-kickstart.5.2.1.SV3.1.2.bin
system variable = bootflash:/n1000v-dk9.5.2.1.SV3.1.2.bin
sup-2
kickstart variable = bootflash:/n1000v-dk9-kickstart.5.2.1.SV3.1.2.bin
system variable = bootflash:/n1000v-dk9.5.2.1.SV3.1.2.bin
Boot Variables on next reload:
sup-1
kickstart variable = bootflash:/n1000v-dk9-kickstart.5.2.1.SV3.1.2.bin
system variable = bootflash:/n1000v-dk9.5.2.1.SV3.1.2.bin
sup-2
kickstart variable = bootflash:/n1000v-dk9-kickstart.5.2.1.SV3.1.2.bin
system variable = bootflash:/n1000v-dk9.5.2.1.SV3.1.2.bin
N1Kv-1-v5_2# sh module
Mod Ports Module-Type Model Status
--- ----- -------------------------------- ------------------ ------------
1 0 Virtual Supervisor Module Nexus1000V active *
Mod Sw Hw
--- ------------------ ------------------------------------------------
1 5.2(1)SV3(1.2) 0.0
Mod Server-IP Server-UUID Server-Name
--- --------------- ------------------------------------ --------------------
1 10.0.0.1 NA NA
* this terminal session
