Hi All,
Our company uses VPLS and on one of the branch sites we have the following connections
VPLS ----PE ----NTU --- ASR 1002 Router ---Switch
I am bit confused about this config. Can some one help me what these configurations ? and is it correct way of doing for VPLS ?
On the ASR 1002 router I have the following config
interface GigabitEthernet0/0/1
description VPLS Connection
bandwidth 200000
ip address x.x.x.x
no ip redirects
no ip proxy-arp
ip flow ingress
load-interval 30
speed 1000
no negotiation auto
cdp enable
service-policy output qos-policy
interface GigabitEthernet0/0/2
description switch port
ip address x.x.x.x
ip nbar protocol-discovery
ip flow ingress
ip pim sparse-dense-mode
ip ospf authentication-key 7 xxxx
negotiation auto
cdp enable
service-policy input class-mark
!
router eigrp 1
network x.x.0.0
On the switch we have
interface GigabitEthernetx/y
description ASr router
ip address X.x.x.x
ip pim sparse-dense-mode
ip ospf authentication-key xxx
mls qos trust dscp
