I currently have a 2811 and a LAN setup via a sub-interface FA0/1.3 and using a HWIC-AP I have a sub-interface dot11radio 0/1.5. I have them setup to work and surf the inet great, but I have recently been overly annoyed with the fact that the wifi cannot access windows shares on desktops and visa versa with the laptops.
The trick to make this happen is currently they are not on the same subnet. I know the answer is bridging the interfaces but when I do this using the simple commands:
bridge 1 protocol ieee
interface x & y
bridge-group 1
Although what should be simple has failed (good thing I tftp'd my working config). Here is my current configuration. Please let me know if there is a way to make this happen.
interface FastEthernet0/1.30
encapsulation dot1Q 30
ip address 192.168.3.1 255.255.255.0
ip nat inside
ip virtual-reassembly in
no ip route-cache
!
interface Dot11Radio0/2/0
no ip address
ip nat inside
ip virtual-reassembly in
!
encryption vlan 50 mode ciphers aes-ccm tkip
!
!
broadcast-key vlan 50 change 30
!
!
ssid MillerNET
!
mbssid
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role root
!
interface Dot11Radio0/2/0.50
encapsulation dot1Q 50
ip address 192.168.5.1 255.255.255.0
no ip proxy-arp
ip nat inside
ip virtual-reassembly in
As always thanks in advance!
