cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
18610
Views
30
Helpful
1
Replies

Can't delete line 2

mlouis
Level 1
Level 1

I'm configuring a new 2911 running c2900-universalk9-mz.SPA.151-4.M4.  In the config by default is "line 2"  its not a vty, aux or console line and I can't remove it,  Has anyone seen this before?

line con 0

exec-timeout 15 30

password Removed

login

line aux 0

line 2

no activation-character

no exec

transport preferred none

transport output none

line vty 0 4

exec-timeout 15 30

password Removed

login

transport input telnet ssh

line vty 5 15

exec-timeout 15 30

password Removed

login

transport input telnet ssh

Thanks

Michael

1 Accepted Solution

Accepted Solutions

InayathUlla Sharieff
Cisco Employee
Cisco Employee

Hi Michael,

This line cannot be removed. Line 2 is reserved for 2nd core console for all

of the ISR G2 platforms. The line is used to provide a console to the

embedded service engine on these platforms.

Conditions: The addition of this line will be seen on all ISR G2 routers if

the version being run has the code which added the console for the second

core.

Workaround: There is no workaround and this line cannot be removed.

HTH

Regards

Inayath

*Plz rate if this info is helpfull.






View solution in original post

1 Reply 1

InayathUlla Sharieff
Cisco Employee
Cisco Employee

Hi Michael,

This line cannot be removed. Line 2 is reserved for 2nd core console for all

of the ISR G2 platforms. The line is used to provide a console to the

embedded service engine on these platforms.

Conditions: The addition of this line will be seen on all ISR G2 routers if

the version being run has the code which added the console for the second

core.

Workaround: There is no workaround and this line cannot be removed.

HTH

Regards

Inayath

*Plz rate if this info is helpfull.






Review Cisco Networking for a $25 gift card