Cannot configure QoS service policy on VLAN interface

[paulmcmanus000]

When trying to configure a service policy on a VLAN interface it comes back with

Switch(config-if)#service-policy input TEST

Master SVI send all failed for interface Vlan310, cmd = 38

Service Policy attachment failed

Switch(config-if)#

Switch is a 3750 stack IOS 12.2(25)SEB4

I can apply policy to other layer 3 interfaces with no problems.

[a-vazquez]

Make sure SDM PREFER ROUTING is enabled and then reload the switch.See if it works out.Refer the following URL

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_tech_note09186a00801e7bb9.shtml

[Sureshdank]

Paul,

service-policy is allowed only on physical interfaces but not in virtual interfaces.

HTH

Regards,

Suresh

[smothuku]

Hi Paul,

The following are the links helps while configuring the policies for 3750.

Policing and policy-maps are only supported on ingress for the 3750. After you configure

the policy map and policing actions, attach the policy to an ingress port by using the

service-policy interface configuration command

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750scg/

swqos.htm#wp1024977

You can attach only one policy map per ingress port

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750scg/

swqos.htm#wp1044737