Cannot configure QoS service policy on VLAN interface

paulmcmanus000 · ‎10-18-2006

When trying to configure a service policy on a VLAN interface it comes back with

Switch(config-if)#service-policy input TEST

Master SVI send all failed for interface Vlan310, cmd = 38

Service Policy attachment failed

Switch(config-if)#

Switch is a 3750 stack IOS 12.2(25)SEB4

I can apply policy to other layer 3 interfaces with no problems.

a-vazquez · ‎10-23-2006

Make sure SDM PREFER ROUTING is enabled and then reload the switch.See if it works out.Refer the following URL

Sureshdank · ‎10-27-2006

Paul,

service-policy is allowed only on physical interfaces but not in virtual interfaces.

HTH

Regards,

Suresh

smothuku · ‎10-27-2006

Hi Paul,

The following are the links helps while configuring the policies for 3750.

Policing and policy-maps are only supported on ingress for the 3750. After you configure

the policy map and policing actions, attach the policy to an ingress port by using the

service-policy interface configuration command

swqos.htm#wp1024977

You can attach only one policy map per ingress port

swqos.htm#wp1044737