cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
32987
Views
15
Helpful
19
Replies

Cannot disable vstack on switch

CartoGraph
Level 1
Level 1

Hello everybody,

 

I'm trying to disable at all vstack on a C3560 and the command "no vstack" doesn't work.

Does anybody know how to disable it? and close the port 4786?

 

 

PORT     STATE SERVICE
4786/tcp open  unknown

 

 

Switch(config)#no vstack
% Incomplete command.


Switch(config)#no vstack ?
  basic             Enable vstack director
  config            Configure default configuration file
  dhcp-localserver  Configure vstack dhcp parameters
  director          Configure director's IP address
  group             Configure a group for vstack
  hostname-prefix   Specify hostname prefix for Client
  image             Configure default image file
  join-window       Configure time interval to enable director
  vlan              Configure vstack management vlan

 

Thank you!!!

19 Replies 19

Thanks a lot... Leo..

ranjit123-
You need to apply the ACL blocking the port on VLAN1. Documentation in this thread shows an example. NOTE that if you have an older version of IOS that has VSTACK there, but not able to be disabled, the blocking of the port with the ACL is your only option, SHORT of upgrading your device to a newer IOS that actually has the DISABLE command.
Zitro68

Thanks a lot everybody...

hi, I applied in all interfaces but still showing listening

SW#show tcp brief all | i 4786
049772BC *.4786 *.* LISTEN

RachelGomez161999
Spotlight
Spotlight

Restart and Use the command "no vstack" or "no vstack config" to disable Smart Install.

Greeting,

Rachel Gomez

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco